Commander 2WD V8-4.7L (2008)
Evaporator Temperature Sensor / Switch: Service and Repair
Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before
performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could
result in accidental airbag deployment and possible personal injury or death.
1. Disconnect and isolate the negative battery cable.
2. Remove the instrument panel silencer from the driver side of the instrument panel.
3. Disconnect the HVAC wire harness connector (1) from the evaporator temperature sensor (2) located on the left side of the HVAC housing (3).
4. Remove the evaporator temperature sensor from the HVAC housing.