Commander 2WD V8-4.7L (2008)
Turn Signal Bulb: Service and Repair
Front Lamp Unit
Removal
BULB - PARK/TURN SIGNAL
1. Disconnect and isolate the battery negative cable.
2. Raise and support the vehicle.
3. Reach into the front wheel house ahead of the front wheel to unsnap and lift the cover over the access hole in the front of the wheel house splash
shield.
4. Reach through the access hole in the splash shield to access the park/turn signal bulb socket (5) on the bottom of the front lamp unit housing.
5. Firmly grasp the socket on the bottom of the front lamp unit housing and rotate it counterclockwise about 30 degrees to unlock it.
6. Pull the socket and bulb straight out from the keyed opening in the housing.
7. Pull the base of the bulb straight out of the socket.
Installation
BULB - PARK/TURN SIGNAL
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
1. Align the base of the bulb with the park/turn signal bulb socket (5).
2. Push the bulb straight into the socket until the base is firmly seated.
3. Align the socket and bulb with the keyed opening on the bottom of the front lamp unit housing.
4. Insert the socket and bulb into the housing until the socket is firmly seated.
5. Rotate the socket clockwise about 30 degrees to lock it into place.
6. Lower and snap the cover back over the access hole at the front of the wheel house splash shield.
7. Lower the vehicle.
8. Reconnect the battery negative cable.
