Commander 2WD V8-4.7L (2008)
4. Position canister (5) into mounting bracket (4). Install and tighten two canister-to-mounting bracket nuts.
5. Position canister/pump assembly to body. Install and tighten three mounting bracket-to-body nuts.
6. Carefully install vapor/vacuum lines (1) and (6) to NVLD pump and EVAP canister. The vapor/vacuum lines and hoses must be firmly
connected. Check the vapor/vacuum lines at the NVLD pump, filter and EVAP canister purge solenoid for damage or leaks. If a leak is
present, a Diagnostic Trouble Code (DTC) may be set.
7. Connect electrical connector (4) to pump.
8. Install plastic splash shield at rear of left-rear tire.
9. Install left-rear tire.
