Commander 2WD V8-4.7L (2008)
1. Remove the third row seat from the vehicle.
2. Remove the screw (5) that secures the seat belt lower anchor (4) to the outboard rear corner of the third row seat support bracket (1).
3. Remove the two screws (4) that secure the seat belt escutcheon (1) to the top of the third row seat back (5).
4. Slide the seat belt webbing (2) through the slot (3) in the escutcheon to remove the escutcheon from the belt.
5. Remove the trim from the back and the top of the third row seat back frame.
6. Remove the through bolt (1) that secures the retainer bracket (2) to the top of the retractor pocket (4) on the front upper outboard corner of the seat
back frame (3).
7. Remove the retractor retainer bracket from the top of the retractor pocket on the seat back frame.
8. Remove the screw (3) below the pull strap (1) from the back of the seat back frame (2) that secures the retractor.
9. Remove the third row seat belt and retractor as a unit from the top of the pocket on the front upper outboard corner of the seat back frame.
