Commander 2WD V8-4.7L (2008)
1. Position the third row seat belt and retractor as a unit through the top of the pocket on the front upper outboard corner of the seat back frame. Be
certain to engage the tab on the retractor into the slot within the pocket.
2. Install and tighten the screw (3) below the pull strap (1) from the back of the seat back frame (2) that secures the retractor. Tighten the screw to 43
Nm (32 ft. lbs.).
3. Position the retractor retainer bracket (2) over the top of the retractor pocket (4) on the front upper outboard corner of the seat back frame (3).
4. Install and tighten the through bolt (1) that secures the retainer bracket to the top of the retractor pocket on the seat back frame. Tighten the bolt to
43 Nm (32 ft. lbs.).
5. Reinstall the trim onto the top and the back of the third row seat back frame.
6. Slide the seat belt webbing (2) through the slot (3) in the seat belt escutcheon (1) and position the escutcheon to the top of the third row seat back
(5).
7. Install and tighten the two screws (4) that secure the escutcheon to the top of the seat back. Tighten the screws to 3 Nm (28 in. lbs.).
