Commander 2WD V8-4.7L (2008)
LEFT SIDE
NOTE: All torques should be done with vehicle on the ground with full vehicle weight.
1. Position the upper suspension arm (2) in the frame rail bracket.
2. Install the mounting bolt (7) and nut (1) tighten to 129 Nm (95 ft. lbs.).
3. Position the upper suspension arm (4) in the axle bracket.
4. Install the mounting bolt (3) and nut (2) tighten to 136 Nm (100 ft. lbs.).
5. Raise the fuel tank back into place and secure See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Tank/Service and Repair/Fuel
Tank - Installation.
6. Remove the supports and lower the vehicle.
Right Side
RIGHT SIDE
NOTE: All torques should be done with vehicle on the ground with full vehicle weight.
