Commander 2WD V8-4.7L (2008)
Suspension Strut / Shock Absorber: Service and Repair
Front Strut / Shock
Removal
CLEVIS BRACKET BUSHING
1. Remove the clevis bracket (3) from the shock (1)See: Clevis Bracket/Removal.
NOTE: On 4X4 vehicles install the C-4212-F between the axle shaft and the lower control in order to allow the tool clearance to press the
bushing in and out.
NOTE: Extreme pressure lubrication must be used on the threaded portions of the tool. This will increase the longevity of the tool and insure
proper operation during the removal and installation process.
2. Press the bushing out using special tools C-4212-F (Press) (1), 9653-1 (driver) (4) and 9653-2 (Receiver) (2) from the lower control arm (3).
Installation
CLEVIS BRACKET BUSHING
