Commander 2WD V8-4.7L (2008)
Shifter A/T: Service and Repair
Installation
INSTALLATION
1. Install shifter assembly (1) in position on the floor pan.
2. Install the bolts (2) to hold the shifter assembly (1) onto the floor pan. Tighten bolts to 12 Nm (105 in.lbs.).
3. Place the floor shifter lever in PARK position.
4. Loosen the adjustment nut (2) on the shifter assembly (1).
5. Install the gearshift cable (3) to the shift lever pin.
6. Install the park lock cable (5) to the shift mechanism cam and the notch in the shifter assembly.
7. Verify that the key is in the LOCK position and remains there until the cable is fully adjusted.
8. Verify that the park lock cable adjustment tab is pulled upward to the unlocked position.
