Commander 2WD V8-4.7L (2008)
5. Pull axle shaft and backing plate out of axle tube until axle bearing (1) is exposed.
6. Remove O-ring (2) from the axle bearing.
7. Remove bearing from axle shaft (1).
8. Remove axle flange bolts.
Installation
INSTALLATION
NOTE: If a bearing flange stud is loose or has backed out tighten stud to 27 Nm (20 ft. lbs.).
1. Install axle flange bolts into axle flange.
2. Install axle shaft into the axle bearing.
3. Install axle shaft (1) with bearing into axle tube and backing plate with new o-ring on axle.
