Commander 2WD V8-4.7L (2008)
Wiper Motor: Service and Repair
Wiper Module - Removal
REMOVAL
NOTE: The front wiper motor can be removed from the wiper module and is serviced independently from the remainder of the wiper module
for this vehicle. See: Wiper Motor - Removal.
1. Disconnect and isolate the battery negative cable.
2. Remove both front wiper arms from the wiper pivots. See: Wiper Arm/Service and Repair/Wiper Arms - Removal.
3. Remove the cowl plenum cover/grille panel from over the front wiper module. See: Body and Frame/Cowl/Cowl Moulding / Trim/Service and
Repair/Cowl Top Panel - Removal.
4. Remove the nut (1) that secures the inboard end of the front wiper module bracket (3) to the stud in the cowl plenum.
5. Remove the two screws (4) that secure the module bracket to the cowl plenum.
6. Disconnect the wire harness connector (2) from the connector receptacle for the front wiper motor.
7. Remove the wiper module from the cowl plenum as a unit.
