Commander 2WD V8-4.7L Flex Fuel (2009)
Parking Assist Control Module: Service and Repair
Park Assist Module - Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Fold and tumble the left outboard second row seat assembly forward.
3. Remove the carpeted cover panel from over the cavity on the left outboard end of the intermediate step assembly (3).
4. Disconnect the underbody wire harness connector (2) from the park assist module (1) connector receptacle. Vehicles with the front park assist
option will have a second connection to the module at this location, which must also be disconnected.
5. Using a trim stick or another suitable wide flat-bladed tool, gently pry the two latch features at the front of the intermediate step cavity away from
the mounting tabs of the module far enough to disengage the forward (connector) side of the module.
6. Pull the module forward far enough to disengage the two mounting tabs on the rear side of the module from the slots in the intermediate step
cavity.
7. Remove the module from the cavity in the intermediate step assembly.
