Commander 2WD V8-4.7L Flex Fuel (2009)
Parking Assist Warning Indicator: Service and Repair
Park Assist Display - Installation
Front
FRONT
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before
attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component
diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper
precautions could result in accidental airbag deployment.
1. Align the bottom of the front park assist display (2) housing with the opening in the escutcheon (3).
2. Using hand pressure, push firmly and evenly on the lens of the display housing to engage the snap clips on the housing into the opening in the
escutcheon.
3. Position the escutcheon and the display to the opening in the instrument panel top pad (4) as a unit to access and reconnect the instrument panel
wire harness connector to the connector receptacle (1) on the bottom of the display housing.
4. Using hand pressure, push firmly and evenly on the top of the display lens to engage the latch features on the escutcheon into the opening in the
instrument panel top pad.
5. Reconnect the battery negative cable.
Rear
REAR
1. Carefully position the rear park assist display (2) through the opening in the face of the headliner (4) with the connector receptacle oriented toward
