Commander 2WD V8-4.7L Flex Fuel (2009)
NOTE: The two outboard rear park assist sensors can be accessed for service with the rear bumper fascia installed on the vehicle.
2. For the two inboard rear park assist sensors only, remove the bumper fascia from the rear of the vehicle. See: Body and Frame/Bumper/Rear
Bumper/Rear Bumper Cover / Fascia/Service and Repair/Rear Bumper Fascia - Removal.
3. From the back of the fascia (4), disconnect the wire harness connector from the park assist sensor (3) connector receptacle.
4. Carefully pry the sensor bracket (1) latch features away from the top and bottom tabs of the sensor far enough to disengage the sensor from the
bracket.
5. Disengage the O-ring spacer (2) from around the circumference of the sensor membrane protrusion.
