Commander 2WD V8-4.7L Flex Fuel (2009)
Body Control Module: Service and Repair
Front Control Module - Installation
INSTALLATION
NOTE: If installing a new service part, remove the plastic cover from the original module and install it on the new one.
1. Connect the Integrated Power Module (IPM) (3) to the Front Control Module (FCM) (1) by lining up the electrical connector and pushing the two
together.
2. Install the four fasteners (2) securing the FCM (1) to the IPM (3).
3. Install the IPM, See: Power and Ground Distribution/Power Distribution Module/Service and Repair/Integrated Power Module (IPM) - Installation
.
4. Connect the battery negative cable.
