Commander 2WD V8-4.7L Flex Fuel (2009)
Rear Door Exterior Handle: Service and Repair
Rear Exterior Door Handle - Installation
INSTALLATION
1. Position the exterior handle (1) to the mounting hole on the outside of the rear door.
2. Install the three bolts (2) that secure that exterior handle to the door. Tighten the bolts to 7 Nm (60 in. lbs.).
3. Connect the actuator rod (1) to the rear exterior handle (2).
4. Install the watershield (1) See: Rear Door Panel/Service and Repair/Watershield - Installation.
5. Adjust the latch See: Rear Door Latch/Adjustments.