Commander 2WD V8-4.7L Flex Fuel (2009)
Rear Door Latch: Service and Repair
Rear Door Latch - Removal
REMOVAL
1. Remove the watershield (1) as necessary to gain access to the latch See: Rear Door Panel/Service and Repair/Watershield - Removal.
2. Disconnect the actuator rod (1) from the exterior handle (2).
3. Disconnect the interior handle actuator rod from the rear door latch (3) and remove the rod.
4. Disconnect the door wire harness connector (2) from the rear door latch.
5. Remove the three bolts (1) that secure the rear door latch to the door and remove the latch and actuator rods as an assembly.
6. If required, remove all of the actuator rods from the actuator.
