Commander 2WD V8-4.7L Flex Fuel (2009)
Hood Hinge: Service and Repair
Hood Hinge - Installation
INSTALLATION
NOTE: It is not necessary to remove the hood to replace the hood hinges. Hood hinges can be replaced one at a time.
1. Position the hood hinge (3) onto the hood (1).
2. Align the hood to the hood hinge using the reference marks made during the removal procedure and Install the bolts (2) that secure the hood hinge
to the hood (1). Tighten the bolts to 28 Nm (21 ft. lbs.).
3. Install the bolts (4) that secures the hood hinge (1) to the fender rail.
4. Align the hood hinge to the hood and the fender rail using the reference marks made during the removal procedure and tighten the bolts to 12 Nm
(9 ft. lbs.).
5. Install the support cylinder (2) See: Hood Shock / Support/Service and Repair/Gas Prop - Installation.
6. If required, adjust the hood to the correct position.