Commander 2WD V8-4.7L Flex Fuel (2009)
Power Trunk / Liftgate Control Module: Service and Repair
Power Liftgate Control Module - Installation
INSTALLATION
1. Position the power liftgate control module (1) into the vehicle.
2. Install the power liftgate control module (1) onto the retaining tabs of the left rear wheel well (2).
3. Connect the wire harness connectors (3) to the power liftgate control module (1).
4. Install the left quarter trim panel, See: Interior Moulding / Trim/Trim Panel/Service and Repair/Luggage Compartment Trim/Quarter Trim Panel -
Installation.
5. Connect the battery negative cable.
6. Using an appropriate scan tool, check and erase any power liftgate control module diagnostic trouble codes.
7. Perform the power liftgate learn cycle, See: Testing and Inspection/Programming and Relearning.
8. Verify power liftgate system operation.
