Commander 2WD V8-4.7L Flex Fuel (2009)
Seat Heater Switch: Service and Repair
Heated Seat Switch - Installation
Front
INSTALLATION
NOTE: There are different instrument panel switch pods available based on the option content of the vehicle. Ensure the switch pod being
installed matches the vehicle options.
1. Position the lower instrument panel switch pod into the instrument panel center bezel.
2. Install the lower instrument panel switch pod fasteners.
3. Install the instrument panel center bezel, See: Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel Bezel -
Installation.
4. Connect the battery negative cable.
5. Verify heated seat system operation.
Second Row
INSTALLATION
1. Install the 2nd row heated seat switch assembly into the floor console rear trim panel. Push the switch firmly into the trim panel until the retaining
tabs are fully seated.
2. If equipped, connect the 2nd row heated seat switches (1), 115 Volt power outlet (3) and the auxiliary audio jacks (2) electrical connectors to the
floor console rear trim panel.
