Commander 2WD V8-4.7L Flex Fuel (2009)
Trunk / Liftgate Position Sensor: Service and Repair
Full Open Switch - Removal
REMOVAL
1. Open the liftgate.
2. Disconnect and isolate the battery negative cable.
3. Remove the power liftgate drive unit, See: Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Motor/Service and Repair/Power Liftgate
Drive Unit Motor - Removal.
CAUTION: Mark the position of the two full open switch wire terminals (2) in relation to their location in the liftgate drive unit wire
connector (1).
4. Using an appropriate wire terminal tool, carefully remove the full open switch wire terminals (2) from the liftgate drive unit connector (1).
5. Remove the full open switch retaining screw (3) from the drive unit assembly (1).
