Commander 2WD V8-4.7L Flex Fuel (2009)
13. Remove camshaft position sensor from right cylinder head.
CAUTION: Care should be taken not to damage the camshaft target wheel. Do not hold the target wheel while loosening or tightening the
camshaft sprocket. Do not place the target wheel near a magnetic source of any kind. A damaged or magnetized target wheel could
cause a vehicle no start condition.
CAUTION: Do not forcefully rotate the camshafts or crankshaft independently of each other. Damaging intake valve to piston contact will
occur. Ensure the negative battery cable is disconnected and isolated to guard against accidental starter engagement.
14. Remove left and right camshaft sprocket bolts.
15. While holding the left camshaft steel tube with adjustable pliers, remove the left camshaft sprocket. Slowly rotate the camshaft approximately 15
degrees clockwise to a neutral position.