Commander 2WD V8-4.7L Flex Fuel (2009)
12. If equipped with dual zone heating-A/C, connect the HVAC wire harness to the blend door actuator (4) located on the passenger side of the air
distribution housing.
13. Connect the HVAC wire harness (3) to the blend door actuator (4) and the mode door actuator (5) located on the driver side of the air distribution
housing (2).
14. Engage the HVAC wire harness retainer (1) to the rear of the air distribution housing.
15. Install the HVAC housing assembly .
Front Air Inlet Housing Removal
HOUSING-AIR INLET
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation See: Service
Precautions/Warning and See: Service Precautions/Caution . Failure to follow the warnings and cautions may result in possible
serious or fatal injury.
WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow
these instructions may result in accidental airbag deployment and possible serious or fatal injury.
NOTE: The air inlet housing must be removed from HVAC housing and disassembled for service of the recirculation-air door.
NOTE: LHD model shown. RHD model similar.
1. Remove the HVAC housing assembly .
2. Disconnect the HVAC wire harness (1) from the recirculation door actuator (2).
3. Remove the three screws (3) that secure the air inlet housing (4) to HVAC housing (5).
4. Tilt the rear of the air inlet housing upward to disengage the two tab-and-slot type retainers located at the front of the inlet housing and remove the
