Commander 2WD V8-4.7L Flex Fuel (2009)
14. Carefully lift the rear A/C evaporator (2) out of the inboard half of the rear HVAC housing (3).
15. Remove the mode-air door (4) and blend-air door (1) from the inboard half of the rear HVAC housing. If the foam seal on any air-door is
deformed or damaged, the air door must be replaced.
Front Air Distribution Housing
HOUSING-AIR DISTRIBUTION
NOTE: The air distribution housing must be removed from the HVAC housing and disassembled for service of the mode-air and blend-air
doors.
1. Install the upper defrost/panel-air door (1), lower defrost/panel-air door (2), directional vane (3) and the blend-air door (4) into the left side air
distribution housing (5) as required. Align the air doors with the pivot shaft holes in the housing.
