Commander 2WD V8-4.7L Flex Fuel (2009)
screws to 2 Nm (17 in. lbs.). If necessary, rotate the actuators slightly to align the splines on the actuator output shaft with those on the mode door
cam and the blend door stop See: Air Door/Air Door Actuator / Motor/Service and Repair/Blend Door Actuator - Installation and See: Air
Door/Air Door Actuator / Motor/Service and Repair/Mode Door Actuator - Installation.
22. Install the air distribution housing onto the HVAC housing .
Front Air Inlet Housing
HOUSING-AIR INLET
NOTE: The air inlet housing must be removed from HVAC housing and disassembled for service of the recirculation-air door.
NOTE: LHD model shown. RHD model similar.
1. Position the recirculation-air door (4) into the air inlet housing (1).
CAUTION: Make sure that the recirculation-air door pivot shaft is properly seated in the pivot seats located on the air inlet housing.
2. Install the recirculation door actuator (3) onto the air inlet housing. If necessary, rotate the actuator slightly to align the splines on the actuator
output shaft with those on the recirculation door pivot shaft See: Air Door/Air Door Actuator / Motor/Service and Repair/Recirculation Door
Actuator - Installation.
3. Install the two screws (2) that secure the recirculation door actuator to the air inlet housing. Tighten the screws to 2 Nm (17 in. lbs.).
4. Install the air inlet housing onto the HVAC housing .
Front HVAC Housing
HOUSING-HVAC ASSEMBLY
CAUTION: Be certain to adjust the refrigerant oil level when servicing the A/C refrigerant system See: Service and Repair/Refrigerant Oil Level
. Failure to properly adjust the refrigerant oil level will prevent the A/C system from operating as designed and can cause serious
A/C compressor damage.
NOTE: When replacing multiple A/C system components, refer to the Refrigerant Oil Capacities chart to determine how much oil should be
added to the refrigerant systemSee: Service and Repair/Refrigerant Oil Level .
NOTE: If the A/C evaporator is being replaced, add 60 milliliters (2 fluid ounces) of refrigerant oil to the refrigerant system. Use only
refrigerant oil of the type recommended for the A/C compressor in the vehicle.
