Commander 2WD V8-4.7L Flex Fuel (2009)
Receiver Dryer: Service and Repair
Front A/C Receiver Drier - Removal
REMOVAL
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation See: Service
Precautions/Warning and See: Service Precautions/Caution . Failure to follow these instructions may result in serious or fatal injury.
1. Disconnect and isolate the negative battery cable.
2. Recover the refrigerant from the refrigerant system See: Service and Repair/Refrigerant System Recovery.
3. Remove the grille See: Body and Frame/Grille/Service and Repair/Grille - Removal.
4. Remove the air cleaner housing and air inlet tube See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner
Housing/Service and Repair/Air Cleaner Body - Removal.
5. Remove the nut (1) that secures the A/C liquid line (2) to the A/C receiver/drier (3).
6. Remove the A/C liquid line from the A/C receiver/drier and remove and discard the dual-plane seal.
7. Remove the screw (4) that secures the A/C receiver/drier to the radiator and fan shroud (5).
8. Remove the nut (6) that secures the A/C receiver/drier to the A/C condenser (7).
9. Disconnect the A/C receiver/drier from the A/C condenser and remove and discard the dual-plane seal.
10. Install plugs in, or tape over the opened receiver/drier fitting and port and the condenser port.
