Commander 2WD V8-4.7L Flex Fuel (2009)
Fog/Driving Lamp Bulb: Service and Repair
Fog Lamp Bulb - Installation
Front
BULB
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb
life will result.
1. Align the base of the bulb with the front fog lamp socket (1).
2. Push the bulb straight into the socket until the base is firmly seated.
3. Align the socket and bulb with the keyed opening on the back of the front fog lamp housing.
4. Insert the socket and bulb into the housing until the socket is firmly seated.
5. Rotate the socket (2) clockwise about 30 degrees to lock it into place. The socket connector receptacle should be pointed straight downward.
6. Reconnect the wire harness connector to the socket.
7. Lower and snap the cover back over the access hole at the front of the wheel house splash shield.
8. Lower the vehicle.
9. Reconnect the battery negative cable.
Rear
BULB
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
NOTE: The following procedure applies only to vehicles manufactured for certain export markets where rear fog lamps are optional or
required equipment. Rear fog lamps are not available in vehicles manufactured for North American markets.
