Commander 2WD V8-4.7L Flex Fuel (2009)
Headlamp Bulb: Service and Repair
Front Lamp Unit Boot - Installation
BOOT - HEADLAMP BULB
CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb
life will result.
1. Position the low beam (upper) or high beam (lower) boot (2) to the back of the front lamp unit housing.
2. Push the inner circumference of the boot down and around the bulb collar formation on the back of the lamp reflector as necessary to fully engage
the boot to the reflector.
3. Push the outer circumference of the boot down and around the boot collar formation on the back of the lamp housing as necessary to fully engage
the boot to the housing.
4. Reinstall the low or high beam headlamp bulb into the front lamp unit. See: .
5. Reinstall the front lamp unit onto the front of the vehicle. See: .
