Commander 2WD V8-4.7L Flex Fuel (2009)
Headlamp Bulb: Service and Repair
Front Lamp Unit Bulb - Removal
BULB - HEADLAMP
CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb
life will result.
NOTE: The following procedure applies to both the low beam (upper) and the high beam (lower) headlamp bulbs. The service procedures for
each bulb are the same, only the bulb location, size and type differ.
1. Disconnect and isolate the battery negative cable.
2. Remove the cover from over the top of the front lamp unit. See: Front Lamp Unit Boot - Removal.
3. Disconnect the pigtail wire connector from the connector receptacle integral to the low beam (upper) or high beam (lower) bulb base (1) on the
back of the front lamp unit housing.
4. Firmly grasp the bulb base and rotate it counterclockwise about 30 degrees to unlock it.
5. Pull the bulb and base straight out from the keyed opening in the reflector.
