Commander 2WD V8-4.7L Flex Fuel (2009)
Marker Lamp Bulb: Service and Repair
Front Side Marker Bulb - Removal
BULB - SIDE MARKER
NOTE: The following procedure applies only to vehicles manufactured for the North American market. Vehicles manufactured for export
markets do not have a bulb, socket or wiring provided to illuminate the front side marker compartment of the front lamp unit. The
front side marker lens is present, but serves only as a reflector on export market vehicles.
1. Disconnect and isolate the battery negative cable.
2. Raise and support the vehicle.
3. Reach into the front wheel house ahead of the front wheel to unsnap and lift the cover over the access hole in the front of the wheel house splash
shield.
4. Reach through the access hole in the splash shield to access the front side marker bulb socket (4) on the back of the front lamp unit housing.
5. Firmly grasp the front side marker bulb socket on the back of the housing and rotate it counterclockwise about 30 degrees to unlock it.
6. Pull the socket and bulb straight out from the keyed opening in the housing.
7. Pull the base of the bulb straight out of the socket.
