Commander 2WD V8-4.7L Flex Fuel (2009)
1. Fold and tumble the second row right outboard seat forward against the front seat for easiest access to the seat latch striker trim (4) and the right
center seat support bracket trim (5).
2. Remove the two screws (1) that secure the trim over the right seat inboard latch striker.
3. Unsnap the right center seat support bracket outer trim from the inner trim, then remove it and the striker trim from the seat as a unit.
4. Remove the screw (3) that secures the second row center seat belt lower anchor (2) to the right center seat support bracket.
5. Remove the upper screw (3) that secures the second row right buckle (1) anchor plate to the right center seat support bracket.
6. Remove the right buckle and anchor plate from the seat as a unit.
Third Row
THIRD ROW
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt
that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or
ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child
restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or
child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new
and unused replacement parts listed in the Chrysler Mopar(R) Parts Catalog.
NOTE: Third row seat belt buckles are only present on vehicles equipped with an optional third row seat.
