Commander 2WD V8-4.7L Flex Fuel (2009)
Seat Belt Height Adjuster: Service and Repair
Seat Belt Turning Loop Adjuster - Installation
INSTALLATION
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt
that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or
ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child
restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or
child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new
and unused replacement parts listed in the Chrysler Mopar(R) Parts Catalog.
1. Position the seat belt turning loop adjuster (5) to the inside of the B-pillar (6).
2. Install and tighten the two screws (1) that secure the adjuster to the B-pillar. Tighten the screws to 39 Nm (29 ft. lbs.).
3. Reinstall the upper trim (2) onto the inside of the B-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/B-Pillar Trim Panel-Installation.
4. Position the seat belt turning loop (4) onto the height adjuster on the upper B-pillar. Be certain that the seat belt webbing between the retractor and
the turning loop is not twisted.
5. Install and tighten the screw (3) that secures the turning loop to the height adjuster. Tighten the screw to 39 Nm (29 ft. lbs.).
6. Insert the upper tabs of the turning loop trim cover into the slots of the height adjuster on the upper B-pillar, then lower the bottom of the cover
and use hand pressure to press firmly and evenly on the cover until it snaps into place.
