Commander 2WD V8-4.7L Flex Fuel (2009)
1. Disconnect and isolate the battery negative cable.
2. Remove the center bezel (1) from the instrument panel. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Instrument Panel Bezel - Removal.
3. Disconnect the wire harness connector from the back of the upper instrument panel switch pod (2).
4. Remove the four screws (3) that secure the switch pod to the back of the center bezel.
5. Remove the upper switch pod from the center bezel.
