Commander 2WD V8-4.7L Flex Fuel (2009)
Battery Cable: Service and Repair
Battery Cables - Removal
REMOVAL
NOTE: It may be necessary to use a battery terminal puller (2) if the battery cable terminal clamps are seized on to the battery posts.
Both the battery negative cable (2) and the battery positive cable (4) are serviced in the battery wire harness (10). If either battery cable is damaged or
faulty, the battery wire harness assembly must be replaced.
1. Turn the ignition switch to the Off position. Be certain that all electrical accessories are turned off.
2. Disconnect the battery negative cable terminal clamp (2) from the battery negative terminal post. If necessary, use a battery terminal puller to
remove the terminal clamp from the battery post.
3. Lift the battery positive cable terminal clamp cover (3) to gain access to the pinch-bolt hex nut.
4. Disconnect the battery positive cable terminal clamp (4) from the battery positive terminal post. If necessary, use a battery terminal puller to
remove the terminal clamp from the battery post.
