Commander 2WD V8-4.7L Flex Fuel (2009)
Seals and Gaskets: Service and Repair
Axle Shaft Seal - Installation
INSTALLATION
NOTE: If a bearing flange stud is loose or has backed out tighten stud to 27 Nm (20 ft. lbs.).
1. Install axle shaft (1) into axle tube and backing plate with new O-ring on axle.
2. Slip O-ring (2) through backing plate, then push axle through backing plate until bearing (1) is exposed.
3. Install new O-ring (2) on axle bearing (1).