Commander 2WD V8-4.7L Flex Fuel (2009)
Axle Shaft: Service and Repair
Installation
INSTALLATION
NOTE: If a bearing flange stud is loose or has backed out tighten stud to 27 Nm (20 ft. lbs.).
1. Tap axle shaft into axle bearing and axle flange.
2. Install axle shaft (1) into axle tube and backing plate with new O-ring on axle.
3. Slip O-ring (2) through backing plate, then push axle through backing plate until bearing (1) is exposed.
4. Install O-ring (2) axle bearing.
