Commander 2WD V8-4.7L VIN P Flex Fuel (2007)
Alarm Horn: Service and Repair
Installation
Bracket
BRACKET
1. Position the alarm siren module (1) with the threaded insert in the siren aligned with the mounting hole in the back of the bracket (2).
2. Install and tighten the screw (3) that secures the bracket to the siren. Tighten the screw to 14 Nm (10 ft. lbs.).
3. Reinstall the siren and bracket as a unit into the hollow on the back of the right end of the front frame crossmember outboard of the right frame
rail.
Siren
SIREN
1. Position the alarm siren module (2) and mounting bracket unit within the hollow on the back of the right end of the front frame crossmember (1)
outboard of the right frame rail.
2. Install and tighten the screw (3) that secures the siren mounting bracket (4) to the right end of the front crossmember. Tighten the screw to 14 Nm
(10 ft. lbs.).
3. Reconnect the headlamp and dash wire harness connector to the connector receptacle near the top of the siren.
4. Reinstall the horn(s) and mounting bracket to the outboard side of the right front frame rail.
5. Lower the vehicle.
