Commander 2WD V8-4.7L VIN P Flex Fuel (2007)
4. Install the drive unit retaining nut (4). Tighten the nut to 28.5 Nm (21 ft. lbs.).
5. Install the drive unit retaining bolts (5). Tighten the bolts to 28.5 Nm (21 ft. lbs.).
6. Connect the wire harness connector to the drive unit assembly (1).
7. Install the left quarter trim panel.
8. Install the left rear D-pillar trim panel.
9. Install the link rod assembly.
10. Connect the battery negative cable.
11. Using an appropriate scan tool, check and erase any power liftgate control module diagnostic trouble codes.
12. Perform the power liftgate learn cycle.
13. Verify power liftgate system operation.
