Commander 2WD V8-4.7L VIN P Flex Fuel (2007)
Trunk / Liftgate Position Sensor: Service and Repair
Installation
INSTALLATION
CAUTION: Be certain the wires are reinstalled in the correct wire cavities. Failure to do so could result in damage to components. Refer to
Wiring Diagrams if uncertain.
1. Position the full open switch (2) onto the power liftgate drive unit assembly (1) and install the retaining screw (3).
2. Ensure the full open switch wire harness (3) is routed properly through the power liftgate drive unit routing tabs (2).
