Commander 2WD V8-4.7L VIN P Flex Fuel (2007)
Engine Mount: Service and Repair
Mount-Engine Front
Removal
REMOVAL
1. Disconnect negative battery cable.
2. Raise vehicle.
3. Remove engine mount thru bolts.
4. Raise engine using suitable jack.
5. Remove engine mount bolts (2).
6. Remove mount (1) from engine.
Installation
INSTALLATION
1. Install the engine mount (1).
2. Torque the bolts to 30 Nm (22 ft.lbs.) torque.
3. Lower the engine.
4. Install the thru bolts and nuts
5. Lower vehicle.
6. Connect negative battery cable.