Commander 2WD V8-4.7L VIN P Flex Fuel (2007)
10. Install the two screws (1) that secure the mode door actuator (2) to the rear of the air distribution housing (3). Tighten the screws to 2 Nm (17 in.
lbs.).
11. Connect the HVAC wire harness connector (4) to the mode door actuator.
12. Install the instrument panel.
13. Reconnect the negative battery cable.
Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before
performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could
result in accidental airbag deployment and possible personal injury or death.
NOTE: LHD model shown. RHD model similar.
1. Disconnect and isolate the negative battery cable.
2. Remove the glove box from the instrument panel.
3. Disconnect the HVAC wire harness connector (1) from the recirculation door actuator (2).
4. Remove the three screws (4) that secure the recirculation door actuator to the HVAC air inlet housing (3) and remove the actuator.
Installation
INSTALLATION
