Commander 2WD V8-4.7L VIN P Flex Fuel (2007)
2. Install the two screws (4) that secure the rear blend door actuator (3) to the rear HVAC housing (1). Tighten the screws to 2 Nm (17 in. lbs.).
3. Connect the rear HVAC wire harness connector (2) to the rear blend door actuator.
4. Install the rear HVAC housing.
5. Initiate the Actuator Calibration function using a scan tool.
Removal
REMOVAL
1. Remove rear HVAC housing (1) and place it on a workbench.
2. Disconnect the rear HVAC wire harness connector (2) from the rear mode door actuator (3).
3. Remove the two screws (4) that secure the rear mode door actuator to the back of the rear HVAC housing and remove the actuator.
Installation
INSTALLATION
