Commander 2WD V8-4.7L VIN P Flex Fuel (2007)
Receiver Dryer: Service and Repair
Removal
REMOVAL
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation. Failure to follow the
warnings and cautions could result in possible personal injury or death.
1. Disconnect and isolate the negative battery cable.
2. Recover the refrigerant from the refrigerant system.
3. Remove the grille.
4. Remove the air cleaner housing and air inlet tube.
5. Remove the nut (1) that secures the A/C liquid line (2) to the A/C receiver/drier (3).
6. Remove the A/C liquid line from the A/C receiver/drier and remove and discard the dual-plane seal.
7. Remove the screw (4) that secures the A/C receiver/drier to the radiator and fan shroud (5).
8. Remove the nut (6) that secures the A/C receiver/drier to the A/C condenser (7).
9. Disconnect the A/C receiver/drier from the A/C condenser and remove and discard the dual-plane seal.
10. Install plugs in, or tape over the opened receiver/drier fitting and port and the condenser port.
