Commander 2WD V8-4.7L VIN P Flex Fuel (2007)
Horn Switch: Service and Repair
Installation
INSTALLATION
WARNING: On vehicles equipped with airbags, refer to electrical, restraints before attempting any steering wheel, steering column, or
instrument panel component diagnosis or service. Failure to take the proper precautions could result in accidental airbag deployment and
possible personal injury.
1. Install the horn switch (2) and tray as a unit into the pouch on the retaining strap of the driver side airbag (5).
NOTE: Be certain that the tray is facing the airbag module, that the horn switch is facing the trim cover, that the horn switch feed wire is on the
left, and that the horn switch ground wire is on the right.
2. Install the trim cover onto the driver side airbag.
3. Connect the battery negative cable.
