Commander 2WD V8-4.7L VIN P Flex Fuel (2007)
NOTE: LHD model shown. RHD model similar.
1. Position the A/C suction line (6) into the engine compartment.
2. Remove the tape or plugs from the suction line fittings and the A/C compressor (2) and A/C expansion valve (8).
3. Lubricate a new O-ring and a dual plane seal with clean refrigerant oil and install them onto the A/C suction line. Use only the specified seals as
they are made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
4. Install the A/C suction line onto the A/C compressor.
5. Install the nut (1) that secures the A/C suction line to the A/C compressor. Tighten the nut to 20 Nm (15 ft. lbs.).
6. Install the A/C suction line onto the A/C expansion valve.
7. Install the nut (7) that secures the A/C suction line to the A/C expansion valve. Tighten the nut to 23 Nm (17 ft. lbs.).
8. Install the air intake tube and the resonator.
9. Reconnect the negative battery cable.
10. Evacuate the refrigerant system.
11. Adjust the refrigerant oil level.
12. Charge the refrigerant system.
Removal
REMOVAL
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation. Failure to follow the
warnings and cautions could result in possible personal injury or death.
