Commander 2WD V8-4.7L VIN P Flex Fuel (2007)
17. Disengage the five mounting brackets that secure the underbody line assembly to the vehicle underbody.
18. Route the underbody line assembly over the rear axle and remove the line assembly from the vehicle.
Installation
INSTALLATION
CAUTION: Be certain to adjust the refrigerant oil level when servicing the A/C refrigerant system. Failure to properly adjust the refrigerant
oil level will prevent the A/C system from operating as designed and can cause serious A/C compressor damage.
NOTE: When replacing multiple A/C system components, refer to the Refrigerant Oil Capacities chart to determine how much oil should be added to
the refrigerant system.
NOTE: Replacement of the refrigerant line O-ring seals and gaskets is required anytime a refrigerant line is opened. Failure to replace the rubber O-ring
seals and metal gaskets could result in a refrigerant system leak.
NOTE: Illustration shown with rear axle removed for clarity.
1. Route the underbody line assembly (2) over the rear axle and position the line assembly to the vehicle underbody (3).
2. Engage the five mounting brackets that secure the underbody line assembly to the vehicle underbody.
3. Install the two screws (1) that secure the underbody line assembly to the front of the underbody. Tighten the screws securely.
4. Install the heat shields as required to the vehicle underbody.
5. Install the muffler and tail pipe as an assembly.
6. Install the rear body cradle.
NOTE: Illustration shown with rear body cradle removed for clarity.
7. Remove the tape or plugs from rear underbody refrigerant line fittings and rear expansion valve ports.
