Commander 2WD V8-4.7L VIN P Flex Fuel (2007)
Power Distribution Module: Description and Operation
Module-Front Control
Description
DESCRIPTION
CAUTION: Do not exchange the Front Control Module with the module from another vehicle. Multiple vehicle module configurations may be
altered. Use only approved service parts when replacing the module or exchanging the module for diagnostic purposes.
The Front Control Module (FCM) (3) is a micro controller based module located in the left front corner of the engine compartment. The FCM mates
directly to the Integrated Power Module (IPM)(2). The IPM connects directly to the battery and provides the primary means of circuit protection and
power distribution for many of the vehicle electrical systems. The FCM controls power to some of these vehicle systems electrical and electromechanical
loads based on inputs received from hard wired switch inputs and data received on the Controller Area Network (CAN) data bus circuit.
Operation
OPERATION
As messages are sent over the Controller Area Network (CAN) bus circuit, the Front Control Module (FCM) reads these messages and controls power to
some of the vehicles electrical systems by completing the circuit to ground (low side driver) or completing the circuit to 12 volt power (high side driver).
The following functions are controlled by the FCM:
-
Front turn signals
-
Turn signal and tail lamps
-
Front and rear hazard warning lamps
-
Headlamps
-
Fog Lamps
-
Daytime running lamps - if equipped
-
Horn
-
Windshield wiper and washer systems
-
Trailer tow wiring output
-
Power Accessory Delay
-
Smart Power Accessory Delay
-
Power adjustable pedals
-
Diesel Cabin Heaters
-
Electric AC Fans
-
Hydraulic/Electronic cooling fan
-
Sensor monitoring (ambient, battery voltage, battery Ignition Off Draw (IOD), brake pedal position, brake fluid level switch and hood ajar - if
equipped)
The FCM provides the following features for the above function:
-
It flashes lamps in response to turn signal, Remote Keyless Entry and Vehicle Theft Security Alarm inputs.
-
It sounds the horn in response to Remote Keyless Entry and Vehicle Theft Security Alarm inputs.
-
It turns off the horn in the event of excessively long operation that could otherwise damage the horn.
-
It minimized voltage variations to the headlamps to extend bulb life.
