Commander 2WD V8-4.7L VIN P Flex Fuel (2007)
Engine Control Module: Testing and Inspection
Programming The SKREEM/WCM Using The Scan Tool
STANDARD PROCEDURE - PROGRAMMING THE SKREEM/WCM USING THE SCAN TOOL
CAUTION: Read all notes and cautions for programming procedures.
1. Connect a battery charger to the vehicle.
2. Connect the scan tool.
CAUTION: If the ECM/PCM and SKREEM/WCM are replaced at the same time, the ECM/PCM MUST be programmed before the
SKREEM/WCM.
3. Select "ECU View".
4. Select "WCM Wireless Control Module".
5. Select "Miscellaneous Functions".
6. Select WCM replaced.
7. Enter the PIN when prompted.
8. Verify the correct information.
