Commander 2WD V8-4.7L VIN P Flex Fuel (2007)
Steering Control Module: All Technical Service Bulletins
Body Controls - No Start After Clockspring Or SCM R & R
NUMBER: 08-019-07
GROUP: Electrical
DATE: July 3, 2007
SUBJECT:
Flash: Remote Start / Tip Start Not Functioning After A Clockspring Or Steering Control
Module Is Replaced
OVERVIEW:
This bulletin involves Flash Reprogramming the Steering Control Module (SCM).
CAUTION:
If this flash process is interrupted/aborted, the SCM will be damaged beyond repair and will require replacement.
MODELS:
2007
(WK)
Grand Cherokee
2007
(WH)
Grand Cherokee (International Markets)
2007
(XK)
Commander
2007
(XH)
Commander (International markets)
NOTE:
This bulletin applies to vehicles built before March 13, 2007 (MDH 0313XX)
SYMPTOM/CONDITION:
Customers may indicate that the remote start/tip start will not functioning after a Clockspring or SCM part replacement.
DIAGNOSIS:
Using a Scan Tool (StarSCAN(R)) with TechCONNECT and the appropriate Diagnostic Procedures, verify all systems are functioning as designed. If
DTC's are present, record them on the repair order and repair as necessary before proceeding further with this bulletin.
If the customer describes the Symptom/Condition and there are no other CCN or temperature sensor issues, perform the Repair Procedure.
SPECIAL TOOLS/EQUIPMENT REQUIRED:
REPAIR PROCEDURE - USING THE INTERNET TO RETRIEVE THE FLASH FILE:
NOTE:
USE THE StarSCAN(R) OR StarMOBILE(R) TO PERFORM THIS PROCEDURE.
