Commander 2WD V8-4.7L VIN P Flex Fuel (2007)
1. If the driver airbag trim cover is being replaced with a new unit, transfer the cruise control switches and the driver airbag jumper harness to the
new trim cover.
2. Place the driver airbag trim cover (4) on a suitable work surface with the airbag receptacle facing up. Be certain to take the proper precautions to
prevent the trim cover from receiving cosmetic damage during the following procedures.
3. Carefully position the driver airbag housing (2) into the trim cover receptacle. Be certain that the horn switch feed and ground pigtail wires are not
pinched between the housing and the upper vertical wall of the trim cover receptacle.
4. Work around the perimeter of the unit engaging each of the 15 hooks (1) on the driver airbag housing through the 15 windows in the walls of the
trim cover receptacle.
5. Using hand pressure, push the integral retainer of the horn switch pigtail wire connector (3) into the locator hole just above the upper left inflator
mounting stud on the back of the airbag housing.
6. Reconnect the driver airbag jumper harness connector (2) to the horn switch pigtail wire connector (3).
7. After the driver airbag has been assembled, try pulling the trim cover and the airbag housing away from each other. This action will fully seat the
edges of the windows into the cradles of the hooks and engage the side walls of the trim cover receptacle under the engagement tabs.
