jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Handling Non-Deployed Supplemental Restraints|Page 9374 > < Solar Sensor, HVAC|Removal|Page 9368
Page 1
background image

Repairs and Inspections Required After a Collision: Service and Repair
Handling Non-Deployed Supplemental Restraints

HANDLING NON-DEPLOYED SUPPLEMENTAL RESTRAINTS

At no time should any source of electricity be permitted near the inflator on the back of a non-deployed airbag or seat belt tensioner. When carrying a
non-deployed airbag, the trim cover or airbag cushion side of the unit should be pointed away from the body to minimize injury in the event of an
accidental deployment. If the airbag unit is placed on a bench or any other surface, the trim cover or airbag cushion side of the unit should be face up to
minimize movement in the event of an accidental deployment.

When handling a non-deployed seat belt tensioner, take proper care to keep fingers away from the scabbard between the buckle and the tensioner unit. In
addition, the supplemental restraint system should be disarmed whenever any steering wheel, steering column, seat belt tensioner, airbag, impact sensor
or instrument panel components require diagnosis or service. Failure to observe this warning could result in accidental airbag deployment and possible
personal injury.

All damaged, ineffective or non-deployed airbags and seat belt tensioners which are replaced on vehicles are to be handled and disposed of properly. If
an airbag or seat belt tensioner unit is ineffective or damaged and non-deployed, refer to the Hazardous Substance Control System for proper disposal.
Dispose of all non-deployed and deployed airbags and seat belt tensioners in a manner consistent with state, provincial, local and federal regulations.

SUPPLEMENTAL RESTRAINT STORAGE

Airbags and seat belt tensioners must be stored in their original, special container until they are used for service. Also, they must be stored in a clean, dry
environment; away from sources of extreme heat, sparks, and high electrical energy. Always place or store any airbag on a surface with its trim cover or
airbag cushion side facing up, to minimize movement in case of an accidental deployment.

Handling Non-Deployed Supplemental Restraints|Page 9374 > < Solar Sensor, HVAC|Removal|Page 9368